Mountain Yotas 4th Gen Tacoma High Clearance Rear Bumper

Mountain Yotas 4th Gen Tacoma High-Clearance Rear Bumper With Integrated Color-Matched Detailing, High Clearance Wings, and Heavy-Duty Recovery Points

Built and welded in-house at Mountain Yotas, the Rear Bumper is the departure-angle answer to its matching front: a high-and-tight rear end that clears ledges and steep transitions instead of dragging on them, all while keeping your factory safety tech reading normally.

We cut the corners high with true high clearance wings, tuck the bumper tight to the bed for maximum departure angle, and keep every factory sensor functional, then finish it with color-matched detailing that looks factory-correct. Everything you need to bolt it on comes in the box.

Current Lead Time: Up to 16 Weeks

Construction

• Main tubes: 1.75" x .120" wall tubing
• Brace tubes: 1.5" x .120" wall DOM tubing
• Mounting plates and all gusseting: 1/4" steel
• Dimple-died steel wing plates, styled for the vinyl underlay
• Color-matched OEM underlays finished to your paint code

Clearance & Geometry

• High clearance wings pull the corners up and out of the way for a serious departure angle improvement over the factory bumper
• Tucked tight to the bed, so nothing hangs below the frame to hook on ledges
• High-and-tight design built to clear the trail, not drag on it

Factory Integration

• All factory park sensors fully retained and functional
• Blind spot monitoring retained, sensors relocated with everything needed to install included
• License plate mount and lighting relocated cleanly, no zip ties, no rigged brackets
• Color-matched underlays matched to your OEM paint code

Recovery & Towing

• Multiple heavy-duty D-ring tabs for straight-line and angled recovery
• Factory hitch receiver and 7-pin connector fully retained and accessible

Recommended Lighting (Save 10% on All Baja Designs Lights)

Use code "10offbaja" to save 10% on all selected Baja Designs lights when you add both light sets to your bumper configuration.

We do not consider lighting optional on this setup. The array we run, all available as options on this page:

• Baja Designs S2 Sport reverse light kit, flush-mounted in the bumper
• Baja Designs S2 rear chase light for dust and low-visibility runs

Finish & Shipping

Ships raw, so the bare steel arrives undamaged with no powder coat to chip or scratch in transit. Having it installed at Mountain Yotas? We powder coat it in-house as part of your build.

Why Mountain Fabrication

Every bumper is built right here in Wheat Ridge, Colorado, by the same team that fabricates our portal axle and custom rigs. No imported castings, no compromises, just DOM tubing, real